Liftmat Low Profile Lift Table

Southworth Liftmat Low Profile Lift Table

• Model: LM2.2-28
• Capacity: 2,200 lbs (uniform)
• Standard Platform Size: 24"W x 60"L
  • Oversized platforms up to 48" x 96" available
• Lowered height: 3-1/8"
• Raised height: 31-1/2"
• Standard voltage: 115/1/60
• Elevating time: 22 seconds (approx)
• Motor: 1 HP
• Weight: 600 lbs (approx)

Optional 30" long ramp available

• In leased buildings or on upper floors where pits can't be built, you can still have the advantage of a roll-on lift table.
• The LIFTMAT by Southworth has a collapsed height of from 3-1/2".
• Travel range is 28-3/8" with a raised height of 31-1/2".
• Platform sizes: minimum size of 24'' x 60'' up to a 48'' x 72'' -- platform size increases in 6'' increments.

NOTE: The LiftMat line is an extremely low profile series of lifts.  They are ideally suited for any application where the load is evenly distributed.  Because there is little "section" or thickness to the legs and platform, the structure does not respond well to off-center or eccentric loads.  When in any raised position, this machine is NOT suitable for any side or hinged end axle loads.  A maximum of 25% end axle load may be applied over the roller end only.