Currencies:  
877-860-3620
CALL TOLL FREE

Standard Verti-Karrier


Call for Price




  • Model: 90
  • Manufactured by: Morse

Morse Auto-Grip Drum Lifter
  • Model: 90
  • Capacity: 1,000lbs
  • For Rimmed 55 gallon steel drums
  • American National Standard ASME B30.20 and a load test certificate is shipped enclosed with each unit

Morse Verti-Karriers

Use Verti-Karrier Drum Lifter hoist attachments to grab and lift your 55-gallon steel drum by gripping under the top rim. Then move and place your drum almost anywhere.

Load a drum to and from remote or hard-to-reach areas

  1. Attach the Verti-Karrier drum grab to your hoist or crane
  2. Move drum picker and lower onto the top of drum
  3. As the drum grab is elevated it grips drum automatically under the top rim
  4. When the drum is lowered to the ground, the drum grab carriage drops down and automatically locks in the open position, releasing the load
  5. The Verti-Karrier drum grab is then ready to lift another drum

The drum picker grip will not disconnect until drum is fully down. You only need to operate your hoist to guide drum grab into position. This saves operator time and protects against dangerous climbing.

Capacity: Lift a drum weighing up to 1,000 Lb. (454 kg).

Model 90 and 90-SS drum lifters are sized for your 55-gallon steel drum (208 liter steel drum). They have 3 different settings, and should be adjusted to grip the sidewall under the rim of your drum.

  • Set in the top hole it will grip to 22-1/16 (56 cm) diameter drum
  • Middle hole to 22-3/16 (56.4 cm) diameter
  • Bottom hole to 22-7/16 57 cm) diameter

Morse Verti-Karrier Drum Lifters are NOT for a drum without lid or top in place.

 

Morse drum lifters comply with ANSI/ASME B30.20 standard for mechanical, below-the-hook lifting devices as it applies to the following:

  • Rated load markings and unit identification
  • Minimum design safety factor of 3, based on yield strength, for load bearing structural components
  • Welding is performed by certified welders who have passed the ANSI/AWS D14.1 welding qualification test
  • All welding is in accordance with ANSI/AWS D14.1 and ASME BTH-1

Call for more information: 877-860-3620